Filter
Top Products
3 Setting Up Your System
30 System Programming Basics
Quick Reference Guide
System Programming Basics
After the control unit is installed, you set up the system by using a combination of
the following two types of programming. Use the System Planning Guide when
programming.
• System Programming allows you to customize the system to meet the
needs of your business. When the system is first installed, it uses factory
settings that reflect the most commonly used options. You can change
system settings as needed.
You can perform System Programming from extension 10 or extension 11.
Because an extension cannot be in programming mode and handle calls at
the same time, you should use extension 11 for programming. By doing so,
you can program without disrupting call handling at extension 10.
• Telephone Programming allows telephones to be customized to meet
individual users’ needs. There are two types of Telephone Programming,
depending from where you program.
— Centralized Telephone Programming—programming individual
telephones from extension 10 or 11.
— Extension Programming—programming an individual system
telephone from the extension to which it is connected.
You need a system display telephone for System and Centralized Telephone
Programming. If you have any 34-button telephones in the system, you must use
a 34-button display telephone to program since an 18-button telephone cannot
be used to program a 34-button telephone. Also, if your system has both
PARTNER and MLS telephones, you should use a PARTNER display telephone
at the programming extension.
• With the PARTNER ACS R7.0 PC Administration software, you can
perform system programming and telephone programming,
enabling you to administer and maintain the PARTNER system from
your PC.
• If the PARTNER system has a T1 module, you must use the
PARTNER ACS R7.0 PC Administration software to configure the
T1 module.