Filter
Top Products
3 Setting Up Your System
System Programming Basics 35
Quick Reference Guide
Programming Mode
When you are ready to program a system or telephone feature, you must enter
programming mode. Follow these steps to enter programming mode.
1 Place the Programming Overlay over the dialpad of the system display
telephone at extension 10 or 11.
2 To enter programming mode, press f00.
3 Press s.
4 Press s again.
5 Specify a programming procedure in one of two ways:
• Direct Method: Dial the code for that procedure. System Programming
procedures in this guide are identified by a # and a three-digit code (for
example, System Date is #101). This method is best when you are using
only a few procedures during a programming session and you know the
codes.
• Cycle Method: Cycle through the procedures in numerical order. Press
N and P to cycle forward and backward through
the programming procedures. This method is best when you are using
multiple procedures during a programming session, or if you do not know
the codes.
6 To exit programming mode, you can press f00. Or you can lift the
handset and then place it back in the cradle.
Changing Programming Type
When you are in programming mode, you can move between System
Programming and Centralized Telephone Programming. To change to
Centralized Telephone Programming when you are in System Programming,
press
c. To move back to System Programming when you are in
Centralized Telephone Programming, press
c, then s.