Filter
Top Products
6 Maintaining Your System
68 Backup and Restore
Quick Reference Guide
4 Press e to start the restore.
If the system detects an error before beginning the restore, the bottom line
of the display shows one of the following messages:
• Insert Card or Insert Valid Card
• Bad File or Bad File-Try Again
• Incompat Version or Incompatible Versions
• Empty File
If the system does not detect an error, the restore begins. One of the
following occurs:
• When the restore has completed successfully, the bottom line of the
display shows Restore Complete for two seconds. All calls in progress
are disconnected, and then the system resets itself. You are no longer in
System Programming mode.
• If the restore is not successful, the display shows Restore Failed or
Restore Failed-Try Again for two seconds. All calls in progress are
disconnected and all of the system and telephone programming settings
revert to the factory settings. You are no longer in System Programming
mode. Try the restore again.
If the Backup/Restore PC Card is fresh from the factory, and no backups
have been recorded on it yet, the filenames are PC CARD MAN
.******
and PC CARD AUTO
.******, respectively. (These file names are also
used for the internal flash memory files.) You cannot use these files for a
restore; they generate the error message Empty File after you press
e in Step 4.