Filter
Top Products
6 Maintaining Your System
80 Replacing Modules
Quick Reference Guide
7 If you are replacing a module with one of a different type, make sure that
the T1 module (if used) or the 1600 DSL module (if used) is in the leftmost
slot, that all 400 (or 200) modules are installed to the right of all 012E,
308EC, or 206 modules, and that the processor module remains in the
center slot.
8 To insert the replacement, once the module is properly seated, firmly push
the center of the module until the connectors on the module lock into place,
and the module is attached to the rear of the carrier. For proper
engagement of the connectors, the module must be inserted straight into
the carrier. A slight click indicates the connectors are engaged.
CAUTION:
Do not force the module. Use the carrier shelf as a reference and do
not tilt, slant or rotate the module. If the module does not insert easily,
remove it, clear any obstruction, and reinsert it.
9 Connect the line and extension cords one at a time, making sure to place
the correct cords into their corresponding jacks on the new module.
• The T1 module is assigned 16 lines, even though it has only one
line jack. If you have a T1 module in a 5-slot carrier, label the line
jacks on the module after the T1 module to begin with “22.”
• The 1600 DSL module is assigned 16 lines, even though it has only
one line jack. If you have a 1600 DSL module in a 5-slot carrier,
label the line jacks on the module after the 1600 DSL module to
begin with “22.”
• PARTNER ACS Release 7.0 supports Endeavor telephones when
an Endeavor 362EC module is installed in the carrier. Install the
Endeavor 362EC module(s) to the right of the T1 module (if
installed) or the 1600 DSL module (if installed) and to the left of all
400 and 200 modules.