Filter
Top Products
6 Maintaining Your System
76 Adding New Modules
Quick Reference Guide
5 Before you insert the new module, make sure that the T1 module (if used)
or 1600 DSL module (if used) is in the leftmost slot and that all 400 (or 200)
modules are installed to the right of all 012E, 308EC, or 206 modules. If you
need to move a module to accommodate the new one, see “Replacing
Modules” on page 77.
6 Push slowly but firmly in the center of the module until the module locks into
place and is attached to the rear of the carrier. Do not force the module. If
the module does not insert easily, remove it, clear any obstruction, and
reinsert it.
7 Connect line and/or extension jack cords to the new module (see
“Connecting Lines and Extensions” on page 23).
8 Reconnect the power cord to the wall outlet.
CAUTION:
The power cord should hang straight down from the connector, flush
against the plastic case. Do not install the power cord at an angle to
the case or with a loop in it.
9 Move the On/Off switch to the “On” position (“—”).
10 Check that all green lights on the fronts of the modules are lit:
• If a single light is out, power down the control unit, reseat the module,
and power up the control unit.
• If multiple lights are out, power down the control unit, reseat the leftmost
module that has a light out, and power up the control unit.
• If the lights are still out, call for support as instructed on the inside front
cover of this guide.
11 Make sure all modules are seated properly. (The cover will not fit if the
modules are not seated properly.)
PARTNER ACS Release 7.0 or later supports Endeavor telephones
when an Endeavor 362EC module is installed in the carrier. Install
the Endeavor 362EC module(s) to the right of the T1 module (if
installed) or the 1600 DSL module (if one is installed) and to the left
of all 400 and 200 modules.