Filter
Top Products
Basic Installation 3-1MN1903
3.1 Introduction
You should read all the sections in Basic Installation.
It is important that the correct steps are followed when installing the NextMove PCI.
This section describes the mechanical and electrical installation of the NextMove PCI.
3.1.1 Hardware requirements
The components you will need to complete the basic installation are described below:
H A PC that fulfills the following specification:
Minimum specification Recommended specification
Processor Intel Pentium 133MHz Intel Pentium 200MHz or faster
RAM 32MB 64MB
Hard disk sp ace 40MB 60MB
CD-ROM ACD-ROMdrive
Screen 800 x 600, 256 colors 1024 x 768, 256 colors
Mouse A mouse or similar pointing device
Operating
system
Windows 95, Windows 98, Windows ME,
Windows NT, Windows 2000 or Windows XP
PCI slot One spare PCI slot
3.1.2 Tools and miscellaneous hardware
H Y our PC operating system u ser m anual might be useful if you are not familiar with Windows.
H A small cross-head screwdriver for fitting the card.
3.1.3 O ther information needed for installation
Yo u will need the following information to complete the installation:
H Knowledge of which digital inputs/outputs will be ‘Active Low’ or ‘Active High’ to meet the
requirements and specification of the system you are going to build.
3 Basic Installation
3