Filter
Top Products
Figure 61. Removing and installing the 3.5 inch (x4) hard-drive backplane
1. release tab (2) 2. hard-drive indicators
3. hard-drive connector (4) 4. guide pin
5. hard-drive backplane
Installing the hard-drive backplane in the hard-drive tray
Prerequisites
1. Ensure that you read the Safety instructions.
2. Follow the procedure listed in Before working inside your system.
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
About this task
Steps
1. Align the hard-drive backplane with the guide pin on the chassis and lower the hard-drive backplane
on the chassis until it is firmly seated.
2. Install the hard-drives carriers in to the hard-drive tray.
3. Install the hard-drive tray in to the chassis.
4. Follow the procedure listed in After working inside your system.
Related video
130