Filter
Top Products
18. TT AND AIS DISPLAYS
18-7
Note 1: The equipment continues to process AIS targets when the AIS feature is
switched off. When the AIS is again turned on, symbols are immediately displayed.
Note 2: AIS symbols are momentarily erased after the screen is redrawn when the
heading is changed from the Head-up mode.
Note 3: When no AIS data is received, the message "AIS receive error" appears in the
[Alert] box. Check the AIS transponder.
Note 4: A target is declared a lost target if it is not detected in five consecutive report-
ing periods.
Note 5: The color of the AIS symbols can be changed. See section 18.1.2.
18.2.2 Voyage data
Before you embark on a voyage, set your navigation status, ETA, destination, draught
and crew, on the [Voyage Data] page in the [NAV Status] menu.
1. Open the MENU then click both [NAV Status] in the [TT/AIS] menu and the [Voy-
age Data] tab.
2. Click the [Navigational Status] drop-down list then select your navigational status,
from the list below.
3. Enter the number of persons onboard (0000-8191) at [Persons].
4. Enter ship's draught (0.0 - 25.5 (m)) at [MAX Draught].
5. Enter your ETA at [ETA].
Day: two digits
Month: Three-character abbreviation
Year: Four digits
6. Enter your destination at [Destination], using a maximum of 20 characters.
7. Click the [Save] button to save the settings.
• Underway using engine
• At anchor
• Not under command
• Restricted maneuverability
• Constrained by her draught
• Moored
• Aground
• Engaged in fishing
• Under way sailing
• Reserved for high speed craft
• Reserved for wing in ground
• Reserved for future use (x3)
• AIS-SART (active)
• Not defined