Filter
Top Products
1. INTRODUCTION
1-13
1.4.4 How to select displays from the menu
You can select the nav data or graphic display to show in the STBY, AUTO(WIND)
and NAV(FishHunter
TM
) modes.
1. Open the [SYSTEM SETUP] menu, select [DISPLAY DATA SELECT MENU] then
push the Course control knob.
2. Rotate the Course control knob to select the mode desired then push the knob.
Rotate the knob to select the display division desired then push the knob. The ex-
ample below shows the display divisions in the STBY, AUTO and NAV modes.
DISPLAY DATA SELECT MENU
STBY
AUTO
NAV
WIND*
* Visible when [SHIP’S CHARACTERISTICS]=sailboat
NAVpilot-700
(When the RRU is installed)
STBY, AUTO, NAV[1]*
1
STBY, AUTO, NAV[2]*
1
STBY, AUTO, NAV[3]*
2
3
STBY, AUTO, NAV[4]*
1
STBY, AUTO, NAV[2]*
1
STBY, AUTO, NAV[3]*
1 2
STBY, AUTO, NAV[5]*
1
STBY, AUTO, NAV[4]*
1 2
NAVpilot-711, 720
(When the RRU is installed)
* “WIND” available when [SHIP’S CHARACTERISTICS]=sailboat
Note: The number of boxes depends on setting of DATA BOX FORMAT in the
DISPLAY SETUP menu in the INSTALLATION menu.
1
2
3
NAVpilot-700
(For Fantum Feedback
TM
)
STBY, AUTO, NAV[2]*
STBY, AUTO, NAV[3]*
1
2
STBY, AUTO, NAV[4]*
1
1
2
3
STBY, AUTO, NAV[3]*
1
STBY, AUTO, NAV[2]*
1 2
NAVpilot-711, 720
(For Fantum Feedback
TM
)