Filter
Top Products
2. STEERING MODES
2-34
4. Use the Course control knob to select [ON] then push the knob.
When this is done the menu items for power assist appear.
5. Use the Course control knob to select [FOR SPEEDS UNDER] then push the
knob.
6. Rotate the Course control knob to set the highest speed at which power assist
activates. The setting range is 1.0 to 9.9 knots.
7. If you want power assist in the STBY mode, use the Course control knob to
set [POWER ASSIST STBY] to [ON].
8. Use the Course control knob to select [POWER ASSIST RUDDER SPEED] then
push the knob.
9. Turn the helm to port and starboard to set safe helm response time then push the
Course Control knob.
10. Press the MENU key to finish.
SAFE HELM/P.ASSIST SETUP
SAFE HELM: ON
RETURN DELAY 5 SEC
SAFE HELM RESPONSE
POWER ASSIST: OFF
FOR SPEEDS UNDER 3.0kn
POWER ASSIST STBY: ON
POWER ASSIST RUDDER SPEED
POWER ASSIST RUDDER SPEED
RUDDER SPEED: 10
TURN HELM PORT/STBD TO
SET RUDDER SPEED.
HIGHER VALUE = FASTER SPEED
PUSH MENU KEY TO CONTINUE
20 10 5 5 10 20