Filter
Top Products
109
Settings
Diagnostics
Displays diagnostic information on NMEA 2000 networks displays the status of
information shared between units (UDB). From the UDB tab, you also can select a
unit to be used as the master (primary) unit when sharing information. To access the
Diagnostics screen, select Diagnostics from the Network menu and press ENTER.
NMEA 2000 receive/send waypoint
Turns on/off the unit’s ability to send and receive waypoints across a NMEA 2000
network. NMEA 0183 receive waypoint controls the unit’s ability to receive way-
points over a NMEA 0183 network.
To turn on/off NMEA send/receive waypoint
commands, highlight the desired NMEA send/
receive option and press ENTER.
Serial Ports
Congures communication ports to send or receive data with another electronic
device, like an autopilot.
To congure serial ports:
1. Highlight Serial Ports on the Network menu
and press ENTER.
2. Select the desired setting and press
ENTER.
3. Use the keypad to select the desired
option and press ENTER.
4. Highlight OK and press ENTER.
NMEA 2000 receive waypoint
turned on
Diagnostics screen: NMEA 2000
Diagnostics screen: UDB
Serial settings menu