Filter
Top Products
114
User-set Allocations Section 4-4
Procedure
Step 1
Set the area, start word, and words allocated for each block using the Config-
urator.
Step 2
Allocate words to all node addresses in each block as shown below using the
Configurator.
• Each address is allocated at least one byte (rightmost or leftmost
byte).
Note a) The order of all blocks can be set as desired by the user.
b) Node addresses do not have to correspond between an output
block and input block.
c) The same node address cannot be allocated more than once.
OUT block 1
Node address 00
Node address 03
Node address 00: DRT1-OD16 (16 output pts)
Node address 03: DRT1-DA02 (2 analog output points = 32 bits)
IN block 1
Node ad-
dress 02
Node address 01: DRT1-ID08 (8 input pts)
Node address 02: DRT1-ID08 (8 input pts)
Node ad-
dress 01
OUT block 1
IN block 2
OUT block 2
IN block 1
OUT block 1
Node address 01
Node address 02
Node address 03
IN block 1
Node address 01
Node address 02
This is not necessary.Example:
Example:
OUT block 1
Node address 02
OUT block 2
Node address 02