Filter
Top Products
227
Maintenance and Replacement Section 9-4
Creating a New Network File
Use the following procedure to write the settings to the DeviceNet Unit from a
network file saved on a disk.
1,2,3... 1. Turn ON power to the DeviceNet Unit, slaves, and the Configurator.
2. Place the Configurator online and display the Device List.
3. Specify the DeviceNet Unit that has been replaced, and use the Edit De-
vice Parameters operation to register slaves and allocate I/O.
4. Write the settings to the devices.
Note 1. When using user-set remote I/O allocations, always save the network file
to a floppy disk or hard disk to restore operation quickly if the DeviceNet
Unit needs to be replaced.
2. When the CPU Unit is replaced, be sure that all data in the DM Area, HR
Area, and other memory areas is transferred to the new CPU Unit before
starting operation.