Filter
Top Products
114
Advanced Setup—Continued
Speaker Levels
You can adjust the volume of each speaker while listening to an input source.
These temporary adjustments are cancelled when the AV controller is set to Standby. To save the setting you made
here, go to “Level Calibration” on page 92 before setting the AV controller to Standby.
Subwoofer 1
–15.0 dB to +12.0 dB (default: 0.0 dB)
Subwoofer 2
–15.0 dB to +12.0 dB (default: 0.0 dB)
Center –12.0 dB to +12.0 dB (default: 0.0 dB)
Notes:
• You cannot use this function while the AV controller is muted.
• Speakers that are set to “No” or “None” in the “Speaker Configuration” cannot be adjusted (see page 90).
• This function will not work when the Pure Audio or Direct listening mode is selected to play analog audio.
Audio Selector
You can set priorities of audio output when there are both digital and analog inputs.
Audio Selector Auto: The AV controller gives priority to analog signals when there is no digital input
(default).
Multich: The AV controller always outputs analog signals from multichannel analog
input.
Balance: The AV controller always outputs analog signals from balanced input.
Analog: The AV controller always outputs analog signals.
Note:
This setting can be made only for the input source that is assigned as HDMI IN, COAXIAL IN, OPTICAL IN,
multichannel input, or balanced input. If both HDMI (HDMI IN) and digital audio inputs (COAXIAL IN or
OPTICAL IN) are assigned, HDMI input will be selected as a priority by setting to “Auto”. To select the digital
audio input, see “Digital Audio Input Setup” on page 51.
A/V Sync
See “A/V Sync” of “Source Setup” on page 98.