Filter
Top Products
43
Turning On the AV controller
European and Asian models: To completely shut down the AV controller, set the [POWER] switch to the OFF position
().
ON/STANDBY ON/STANDBY
POWER
STANDBY
ON
RECEIVER
STANDBY indicator
(North American models)
(European and Asian models)
STANDBY indicator
Turning On and Standby
1
(European and Asian models)
Set the [POWER] switch to the ON position ( ).
2
On the AV controller, press the [ON/STANDBY] button.
On the remote controller, press the [RECEIVER] button, followed by the
[ON] button.
The AV controller comes on, the display lights up, and the STANDBY indicator goes
off.
Pressing the remote controller’s [ON] button again will turn on any components
connected via .
To turn the AV controller off, press the [ON/STANDBY] button, or press the remote
controller’s [STANDBY] button. The AV controller will enter Standby mode. To
prevent any loud surprises when you turn on the AV controller, always turn down the
volume before you turn it off.
or
Remote
controller
AV controller
Smooth Operation in a Few Easy Steps
To ensure smooth operation, here’s a few easy steps to help you configure the AV controller before you use it for the
very first time. These settings only need to be made once.
■ Did you connect your TV to an HDMI output or COMPONENT VIDEO MONITOR OUT?
If you did, “Monitor Setup” on page 44.
■ Run MultEQ XT Room Correction and Speaker Setup—this is essential!
See “Audyssey MultEQ
®
XT Room Correction and Speaker Setup” on page 56.
■ Have you connected a component to an HDMI input,
component video input, or digital audio input?
If you have, see “HDMI Input Setup” on page 49, “Component Video
Input Setup” on page 50, or “Digital Audio Input Setup” on page 51
respectively.
■ Have you connected an Onkyo MD recorder, CD recorder,
or RI Dock?
If you have, see “Changing the Input Display” on page 55.
HDMI
OUT IN
TV/TAPE
MD recorder, CD recorder,
RI Dock