Filter
Top Products
42
Connecting the AV controller—Continued
With (Remote Interactive), you can use the follow-
ing special functions:
■ Auto Power On/Standby
When you start playback on a component connected
via , if the AV controller is on Standby, it will
automatically turn on and select that component as
the input source. Similarly, when the AV controller is
set to Standby, all components connected via
will also go on Standby.
■ Direct Change
When playback is started on a component connected
via , the AV controller automatically selects that
component as the input source.
■ Remote Control
You can use the AV controller’s remote controller to
control your other -capable Onkyo components,
pointing the remote controller at the AV controller’s
remote control sensor instead of the component. You
must enter the appropriate remote control code first
(see page 136).
Notes:
• Use only cables for connections. cables
are supplied with Onkyo players (DVD, CD, etc.).
• Some components have two jacks. You can con-
nect either one to the AV controller. The other jack is
for connecting additional -capable components.
• Connect only Onkyo components to jacks. Con-
necting other manufacturer’s components may cause a
malfunction.
• Some components may not support all functions.
Refer to the manuals supplied with your other Onkyo
components.
• While Zone 2 or Zone 3 is on, the Auto Power
On/Standby and Direct Change functions do not
work.
Notes:
• Before connecting the power cord, connect all of
your speakers and AV components.
• Turning on the AV controller may cause a momentary
power surge that might interfere with other electrical
equipment on the same circuit. If this is a problem,
plug the AV controller into a different branch circuit.
• Do not use a power cord other than the one supplied
with the AV controller. The supplied power cord is
designed exclusively for use with the AV controller
and should not be used with any other equipment.
• Never disconnect the power cord from the AV control-
ler while the other end is still plugged into a wall out-
let. Doing so may cause an electric shock. Always
disconnect the power cord from the wall outlet first,
and then the AV controller.
Connecting Onkyo Components
Step 1:
Make sure that each Onkyo component is connected
to the AV controller with an analog audio cable (con-
nection in the hookup examples) (see pages 31 to
40, 41).
Step 2:
Make the connection (see illustration right).
Step 3:
If you’re using an MD, CDR, or RI Dock, change the
Input Display (see page 55).
a
Connecting the Power Cord
L R
IN
DVD/BD
L
R
IN
CD
L
R
REMOTE
CONTROL
ANALOG
AUDIO OUT
L R
ANALOG
AUDIO OUT
e.g., CD player
e.g., DVD player
Step 1:
Connect the supplied power cord to the AV control-
ler’s AC INLET.
Step 2:
Plug the power cord into an AC wall outlet.
To AC wall outlet