Filter
Top Products
136
Controlling Other Components—Continued
Onkyo components that are connected via are con-
trolled by pointing the remote controller at the AV con-
troller, not the component. This allows you to control
components that are out of view, in a rack, for example.
If you want to control an Onkyo component by pointing
the remote controller directly at it, or you want to control
an Onkyo component that’s not connected via , use
the following remote control codes:
• [DVD/BD] button
30627: Onkyo DVD player without (default)
•[CD] button
71817: Onkyo CD player without (default)
• [TV] button
11807: TV with (default)
If you want to control an Onkyo component by pointing
the remote controller directly at it, use the following
remote control codes:
32900: Onkyo BD player
32901: Onkyo HD DVD player
70868: Onkyo MD recorder
71323: Onkyo CD recorder
81993: Onkyo RI Dock with
Note:
If you connect an -capable Onkyo RI Dock to the
TV/TAPE, VCR/DVR, or GAME jacks, for to work
properly, you must set the Input Display accordingly
(see page 55).
You can reset a REMOTE MODE button to its default
remote control code.
You can reset the remote controller to its default settings.
Remote Control Codes for Onkyo
Components Connected via
1
Make sure the Onkyo component is con-
nected with an cable and an analog
audio cable (RCA).
See page 42 for details.
2
Enter the appropriate remote control code
for the REMOTE MODE button.
•[DVD/BD] button
31612: Onkyo DVD player with
• [CD] button
71327: Onkyo CD player with
• [TV/TAPE] button
42157: Onkyo cassette recorder with
(default)
• [PORT] button
82351: Onkyo Dock (default)
See the previous page for how to enter remote
control codes.
3
Press the REMOTE MODE button, point
the remote controller at the AV controller,
and operate the component.
Resetting REMOTE MODE Buttons
1
(3 seconds)
While holding down the REMOTE
MODE button that you want to
reset, press and hold down the
[AUDIO] button until the REMOTE
MODE button lights up (about 3
seconds).
2
Within 30 seconds, press the
REMOTE MODE button again.
The REMOTE MODE button flashes
twice, indicating that the button has
been reset.
Each of the REMOTE MODE buttons
is preprogrammed with a remote con-
trol code. When a button is reset, its
preprogrammed code is restored.
Note:
The learning command is also reset.
Resetting the Remote Controller
1
(3 seconds)
While holding down the
[RECEIVER] button, press and
hold down the [AUDIO] button
until the [RECEIVER] button
lights up (about 3 seconds).
2
Within 30 seconds, press the
[RECEIVER] button again.
The [RECEIVER] button flashes twice,
indicating that the remote controller
has been reset.