Filter
Top Products
53
First Time Setup—Continued
If you’ve fed your front speakers from the FRONT L/R
and SURR BACK L/R outputs for bi-amping, you must
change the “Speakers Type(Front)” setting. For hookup
information, see “Bi-amping the Front Speakers” on
page 21.
Notes:
• When bi-amping is used, the AV controller is able to
feed up to 7.2 speakers in the main room.
• Before you change these settings, turn down the
volume.
Note:
This procedure can also be performed on the AV control-
ler by using its [SETUP] button, arrow buttons, and
[ENTER] button.
Speaker Settings
1
Press the [RECEIVER] button,
followed by the [SETUP] button.
The main menu appears onscreen.
If the main menu doesn’t appear, make
sure the appropriate external input is
selected on your TV.
2
Use the Up and Down [ ]/[ ] but-
tons to select “2. Speaker
Setup”, and then press [ENTER].
The “Speaker Setup” menu appears.
3
Use the Up and Down [ ]/[ ] but-
tons to select “1. Speaker Set-
tings”, and then press [ENTER].
The “Speaker Settings” menu appears.
If you change these settings, you must run
Audyssey MultEQ
®
XT Room Correction and
Speaker Setup again (see page 56).
2. Speaker Setup
1. Speaker Settings
2. Speaker Configuration
3. Speaker Distance
4. Level Calibration
5. Equalizer Settings
6. THX Audio Setup
2–1. Speaker Settings
Speakers Type(Front) Normal
4
Use the Up and Down [ ]/[ ] but-
tons to select “Speakers
Type(Front)”, and then use the
Left and Right [ ]/[ ] buttons to
select:
Normal: Select this if you’ve con-
nected your front speakers
normally.
Bi-Amp: Select this if you’ve con-
nected your front speakers
for bi-amped operation.
Note:
Surround back speakers cannot be used
if you select “Bi-Amp”.
5
Press the [SETUP] button.
The setup menu closes.