Filter
Top Products
GPS Chart Plotters Page 19
2.4.2.2 Connection of the FF520, AIS receiver, VHF and Autopilot
NOTE
Port 2 input and output is used by the optional FF520. In the diagram above you will notice Port 2
Input and Output wires are shown in gray and not used.
AIS Setup
The CP180 or CP180i has to be setup to be able to receive NMEA information from the AIS
receiver.
1. Press [Menu], move the ShuttlePoint knob to highlight
SETUP MENU and press [ENT].
2. Move the ShuttlePoint knob to highlight
ADVANCED SETUP and press [ENT] or move
the ShuttlePoint knob to the right.
3. Move the ShuttlePoint knob to highlight
IN/OUT CONNECTIONS and press [ENT] or
move the ShuttlePoint knob to the right.
4. Move the ShuttlePoint knob to highlight
PORT 1 INPUT and press [ENT] or move the
ShuttlePoint knob to the right.
5. Move the ShuttlePoint knob up/down to select
AIS 38400 and press [ENT] or move the
ShuttlePoint knob to the right.