Filter
Top Products
GPS Chart Plotters Page 25
2.12 DEMO MODE (FOR DEALER USE)
NOTE
When the PIP video window is shown, the ShuttlePoint knob can be used to move the position of
the PIP window or move the cursor around the chart page. By default the PIP window is controlled
by the ShuttlePoint knob. To change so the chart cursor can be moved, press any Soft Key, then
press [V
IDPAGE]. To change back to control the PIP window press any Soft Key, then press [VIDPAGE]
again.
NOTE
When the PIP window is shown, the cursor and the vessels position may be shown under the PIP
window.
In Demo mode the GPS Chart Plotter automatically places a Destination point on the Chart
page and simulates navigation to the point. Also, the active page changes automatically
every 10 seconds. The pages are shown in the following order: Start-up screen, GPS
Status, Chart/General window, Chart/Compass tape, Chart/Fish, Full page Fish, Naviga-
tion page, Highway Page, Celestial page, NMEA Page.
NOTE
This mode is use by selling dealers to promote the features of the GPS Chart Plotter when on a retail
shelf.
The Demo mode can be selected from the Simulation Menu following the procedure:
1. Press [MENU]. Move the ShuttlePoint knob to highlight
SETUP MENU and press [ENT].
2. Move the ShuttlePoint knob to highlight
ADVANCED SETUP and press [ENT] or move
the ShuttlePoint knob to the right.
3. Move the ShuttlePoint knob to highlight
SIMULATION and press [ENT] or move the
ShuttlePoint knob to the right.
4. Move the ShuttlePoint knob to highlight
DEMO MODE and press [ENT] or move the
ShuttlePoint knob to the right to show the popup window.
5. Move the ShuttlePoint knob to select
On and press [ENT] or move the ShuttlePoint knob
to the right.
6. Demo mode is now activated.
Once the Demo mode is enabled, pressing any key it is possible to temporally exit and
returns to GPS Chart Plotter normal operation, but if you do not touch any key for 30 seconds
Demo mode re-starts.
To disable Demo mode follow the procedure above selecting
Off at point 5.