Filter
Top Products
Page 26 CP500
ShuttlePoint knob to the desired selection and press [ENT] or move the ShuttlePoint
knob to the right.
5. Press [CLR] or move the ShuttlePoint knob to the left to exit the menu and show the
Chart page.
NOTE
When the GPS Chart Plotter is in COURSE UP mode a small arrow icon will be shown on the
Chart page indicating the direction of North.
3.2 ADJUSTING THE TIME
The time information supplied by the GPS satellites is in Universal Time Coordinates (UTC or
Greenwich England Mean Time). To change the GPS Chart Plotter to read the correct time, first
you must figure out the offset and if it is daylight savings time. For example on the West coast of
the United States or Pacific Standard Time the offset needed would be –08:00 or –07:00 for daylight
savings time, Eastern Standard Time –05:00 or –04:00 for daylight savings time.
Figure 3.2 - Adjusting Time
NOTE
This map shows offset for standard time. For daylight saving time, subtract one hour from the offset time.
Figure 3.2a - Time Setup menu
1. Press [MENU]. Move the ShuttlePoint knob to highlight SETUP MENU and press [ENT].