Filter
Top Products
CP500 Page 51
9. ROUTES
The CP500 has the capability to store 50 Routes with a maximum of 50 Waypoints each.
A Route can consist of Waypoints or Marks. The difference is when a Route is made using
Waypoints and the Route is deleted the Waypoints are also deleted. However if a Route is
made of Marks and the Route is deleted the Marks stay in memory.
9.0 CREATING A ROUTE USING WAYPOINTS
1. On the Chart page move the ShuttlePoint knob to the Lat/Lon of the starting Waypoint
in the Route.
2. Press [ROUTE], you will notice the Starting Waypoint
will be placed under the cursor.
3. Move the ShuttlePoint knob to the second Lat/Lon of the next leg
in the Route.
4. Press [ROUTE]. You will notice another Waypoint is shown under the cursor and a line
joins the starting Waypoint to the Second Waypoint.
Figure 9.0 - Creating a Route using Waypoints
5. Repeat steps 3 and 4 until all Waypoints are entered into the Route.
NOTE
At this point the Route is saved as ROUTE01. If you would like to save the Route under a specific
name follow the next steps.
9.1 CHANGING NAME TO A ROUTE
To name the Route:
1. Place the ShuttlePoint knob on the Route (on Waypoint or on leg) and press [R
EPORT].
2. Move the ShuttlePoint knob to highlight
NAME and press [ENT]. A popup window will
be shown.
3. Move the ShuttlePoint knob up/down to change the characters and left/right to select
a different character in the Routes Name.