Filter
Top Products
November 2003 © TOSHIBA TEC 3 - 57 e-STUDIO3511/4511 ADJUSTMENT
(4) Remove the stepped screw at the rear of
right-hand hinge.
(5) Open the RADF, and then loosen 2 hand
screws 1 turn (status of tentative fixing).
(6) Remove the positioning pin at the front side.
Close the RADF to fit the positioning pin into
the hole at the rear side of the RADF. While
peering inside from the front side, fit the
positions of the pin and hole by moving the
RADF right and left.
(7) Tighten the positioning pin at the front side.
Close the RADF to fit the positioning pin into
the hole at the front side of the RADF. (For
the front side, adjust the RADF position all
around.)
Screw
Fig. 3-1204
Fig. 3-1205
Fig. 3-1206
Fig. 3-1207