Filter
Top Products
November 2003 © TOSHIBA TEC 5 - 69 e-STUDIO3511/4511 TROUBLESHOOTING
[CCF0] Gear change motor abnormality
MJ-1023/1024
Is the gear change home position sensor (PI49) normal?
NO Replace the sensor.
YES
Is the wiring between the finisher controller PC board and the gear change motor (M40) correct?
NO Correct the wiring.
YES
Is there any problem with the gear change mechanism?
YES Fix the gear change mechanism.
NO
1. Replace the gear change motor.
2. Replace the finisher controller PC board.
[CE00] Communication error between finisher and puncher unit
MJ-1023/1024 (When MJ-6004 is installed)
Is the problem solved by turning OFF and ON the power of the equipment?
YES End.
NO
Is the wiring between the finisher controller PC board and punch controller PC board correct?
NO Correct the wiring.
YES
1. Replace the finisher controller PC board.
2. Replace the punch controller PC board.