Filter
Top Products
November 2003 © TOSHIBA TEC 4 - 21 e-STUDIO3511/4511 PREVENTIVE MAINTENANCE
Fig. 4-216
Fig. 4-217
*m1. Separation finger
The paper jam may be caused if the tip of the finger is damaged or deformed. If there is any
problem with it, replace the finger with a new one regardless of the number of output pages
which have been made. Do not damage the tip of the finger during the cleaning. The finger may
be damaged if the toner adhering to the tip of it is scraped off forcibly. Replace the finger if the
toner is sticking to it heavily.
*l1. Paper guide
Clean the surface of the paper guide (denoted in the figure) with a piece of dry cloth.
When cleaning, do not touch the surface of the transfer belt with bare hands.
*k5. Paper clinging detection sensor
Open the ADU and clean the paper clinging detection sensor with a cotton swab, etc.
Note:
Clean the entire area (denoted in the figure below) of the sensor surface.
04/05