Filter
Top Products
November 2003 © TOSHIBA TEC 6 - 29 e-STUDIO3511/4511 FIRMWARE UPDATING
(5) Change the setting of the DIP switch on the finisher contorol PC board.
Change the setting of the DIP switch as follows according to the firmware to be updated.
Note:
Record the current settings of the DIP switch before changing them. After the updating is
completed, return the DIP switch to the status as record.
<Updating Finisher Firmware>
Change all the setting of the DIP switch (1-8) to OFF.
<Updating Saddle Stitcher Firmware>
Change the setting of the DIP switch 1-6 to OFF and 7-8 to ON.
(6) Turn ON the power while [0] button and [8] button are pressed simultaneously.
Updating starts automatically and the LED on the download jig lights.
Tip:
The processing status can be confirmed by the lighting of the LED (LED 101-103) on the finisher
control board.
Processing status
0% or above
15% or above
30% or above
45% or above
60% or above
75% or above
90% or above
LED103
OFF
OFF
OFF
ON
ON
ON
ON
LED102
OFF
ON
ON
OFF
OFF
ON
ON
LED101
ON
OFF
ON
OFF
ON
OFF
ON
LED