104 Settings | Control Panel Options
MX7 Reference Guide E-EQ-MX7RG-B
Network and Dialup Connections
Access: | Settings | Control Panel | Network and Dialup Connections
Set network driver properties and network access properties. Select a connection to use, or create
a new connection on the MX7.
Odyssey Client Connection Panel Summit Client Connection Panel
Figure 3-19 Network and Dialup Connections
Tap OK to save the settings or tap the “X” button to ignore changes. Tap the “?” box for Help.
Create a Connection Option
1. On the mobile device, select | Settings | Control Panel | Network and Dialup
Connections. A window is displayed showing the existing connections.
2. Assuming the one you want does not exist, double-tap Make New Connection.
3. Give the new connection an appropriate name (My Connection @ 9600, etc.). Tap the Direct
Connection radio button. Tap the Next button.
4. From the popup menu, choose the port you want to connect to. Only the available ports are
shown.
5. Tap the Configure... button.
6. Under the Port Settings tab, choose the appropriate baud rate. Data bits, parity, and stop bits
remain at 8, none, and 1, respectively.
7. Under the Call Options tab, be sure to turn off Wait for dial tone, since a direct connection
will not have a dial tone. Set the timeout parameter (default is 5 seconds). Tap OK.
8. TCP/IP Settings should not need to change from defaults. Tap the Finish button to create the
new connection.
9. Close the Remote Networking window.
10. To activate the new connection select
| Settings | Control Panel | PC Connection and tap
the Change Connection… button.
11. Select the new connection. Tap OK twice.
