Summit Client Configuration 185
E-EQ-MX7RG-B MX7 Reference Guide
Wireless Security
Use the instructions in this section to complete the entries on the Config tab according to the type
of wireless security used by your network. The instructions that follow are the minimum required
to successfully connect to a network. Your system may require more parameters than are listed in
these instructions. Please see your System Administrator for complete information about your
network and its wireless security requirements.
Note: It is important that all dates are correct on CE computers when using any type of
certificate. Certificates are date sensitive and if the date is not correct authentication will
fail.
Default profile LXE recommends editing the Default profile instead of creating new
profiles. Important: Perform a Warm Reset (or Suspend/Resume)
after changing parameters to save the changed parameters in the
registry.
Switching profiles Successfully connecting after switching from one profile to another
may take up to 30 seconds from the moment the “Is not authenticated”
message is displayed.
Adding, changing or
renaming profiles
LXE recommends performing a Warm Reset function (or
Suspend/Resume) after tapping the Commit button.
No Security
Start the Summit Utility by tapping the Summit Client icon.
Tap the Admin Login button on the Main panel. Enter the Administrator password and tap OK.
Tap the Config tab.
Enter the SSID of the Access Point assigned to
this profile.
Set Auth Type to Open.
Set EAP Type to None.
Set Encryption to None.
Tap the Commit
3
button to save the new
profile configuration.
Perform a Warm Reset function to connect
using the new profile configuration.
Figure 5-7 Configure a Summit Profile with No Security
3
LXE recommends performing a warm reset or Suspend/Resume function each time the Commit button is
tapped.
