20 Software Setup
MX7 Reference Guide E-EQ-MX7RG-B
Software Setup
Touchscreen Calibration
Note: The first time it is used, the MX7 automatically runs the touchscreen calibration
program.
If the MX7 is not responding properly to stylus touch taps, the touchscreen may need to be
recalibrated.
To recalibrate the screen, tap the
| Settings | Control Panel | Stylus | Calibration tab.
Tap the Recalibrate button. Follow the instructions on the screen and press the Enter key to save
the new calibration settings or press <Esc> to cancel or quit.
Set Time Zone (Optional)
Note: The first time it is used, or the device returns from a Cold Reset, the MX7 resets Date
and Time to the factory default values.
To set the Time Zone, tap the
| Settings | Control Panel | Date/Time icon.
Select the physical time zone. Enable the checkbox next to “Automatically adjust clock for
daylight saving” if applicable.
Adjust the time and calendar date and tap Apply. Tap OK when you are finished or X to ignore
any changes.
Enter Owner Information (Optional)
Use the virtual keyboard or keys on the keypad to enter the following data.
To set Owner information, tap the
| Settings | Control Panel | Owner icon.
Select the Identification tab, and enter Name, Company, Address, and telephone numbers. Enable
the “Display owner identification” checkbox if you want this information displayed each time the
system powers on.
Select the Notes tab, enter a note to see at power on. Enable the “display owner notes” checkbox
to see the note at power on.
Select the Network ID tab and enter the User Name, Password and Domain.
Tap OK when finished or X to ignore any changes.
