Funk Odyssey Client Configuration 191
E-EQ-MX7RG-B MX7 Reference Guide
Funk Odyssey Client Configuration
Odyssey Client Icon
Start the Funk Odyssey client configuration by tapping the Odyssey Client icon on the desktop or
in the taskbar at the bottom right corner of the screen.
To create a Funk Odyssey Client user login, please refer to Chapter 3 “System
Configuration”, section titled “LXE Login Utility.”
For additional information on the Odyssey client see the Funk web site at www funk com.
Note: LXE recommends using the Funk Odyssey client to configure the radio. Wireless Zero
Config is not recommended for configuring the radio, although it can be used to reveal
the IP address.
Prerequisites
• Network SSID or ESSID number of the Access Point
• WEP or LEAP Authentication Protocol Keys
Odyssey Client Menu
Settings
Factory Default Settings
Settings
Configure
Networks Blank
Detailed Status Refresh
Security Settings
Session Resumption 12 hours, Enabled
Automatic Reauthentication Disabled
Temporary Trust 12 hours, Enabled
EAP-FAST Settings
Acquire credentials from new server Enabled
Replace credentials upon failure Enabled
Trusted Servers Blank
Disable Odyssey Immediate disabling
Exit
Figure 5-17 Odyssey Client Screens – Settings
Configure Use this option to edit, add and delete networks.
Detailed Status Configure advanced security options related to authentication.
Security
Settings
This option allows the user to enable session resumption, automatic
reauthentication and server temporary trust.
EAP-FAST
Settings
Configure Odyssey to prompt for permission before acquiring new EAP-
FAST credentials.
