Filter
Top Products
1-15
Install, Upgrade, and Maintenance Guide for Cisco Unity Connection Release 10.x
Chapter 1 Installing Cisco Unity Connection
Installation Tasks
Configuring Subscriber Server on the Publisher Server
To Configure Subscriber server on the publisher server
Step 1 Sign in to Cisco Unity Connection Administration.
Step 2 Expand System Settings and select Cluster.
Step 3 On the Find and List Servers page, select Add New.
Step 4 On the New Server Configuration page, in the Hostname or IP Address field, enter the hostname or IP
address of the second server in the cluster.
Step 5 (Optional) In the MAC Address field, enter the MAC address of the second server.
Step 6 In the Description field, enter a description for the second server and select Save.
Installing the Subscriber Server
To install the subscriber server, follow the steps of installing publisher server until the First Node
Configuration window appears and then continue the following procedure.
While installing a Unity Connection server, you are prompted to enter different configuration
information. Refer the table mentioned in the Gathering Information for Installation, page 1-5 section
wherever applicable.
To Install a Subscriber Server
Step 1 In the Console tab, on the First Node Configuration window, select No to continue the installation of
the subscriber server and select OK.
The Network Connectivity Test Configuration window displays.
Step 2 During installation of a subscriber server, the system checks to ensure that the subscriber server can
connect to the publisher server.
• To pause the installation after the system successfully verifies network connectivity, select Yes.
• To continue the installation, select No.
The First Node Access Configuration window displays.
Step 3 Enter the connectivity information for the publisher server and select OK.
The system checks for network connectivity.
If you select to pause the system after the system successfully verifies network connectivity, the
Successful Cisco Unity Connection to First Node window displays. Select Continue.
Note If the network connectivity test fails, the system stops and allows you to go back and re-enter
the parameter information.
The SMTP Host Configuration window displays.
Step 4 If you want to configure an SMTP server, select Yes and enter the SMTP server name.
The Platform Configuration Confirmation window displays.