116
Troubleshooting
bubbles. (See the Installation Section for how to install the
transducer.)
When attaching a transducer to the inside of a hull, ONLY 3.
use epoxy available from LEI (see inside back cover for or-
der information).
Do NOT use RTV silicone rubber adhesive or any other type 4.
of epoxy. The LEI epoxy is specially formulated so that it will
cure properly for shoot-through applications.
Clean the face of the transducer. Oil, dirt and fuel can cause 5.
a lm to form on the transducer, reducing its effectiveness.
Electrical noise from the boat’s motor or trolling motor can 6.
interfere with the sonar. This causes the sonar to automati-
cally increase its discrimination or noise rejection feature.
This can cause the unit to eliminate weaker signals such as
sh and can display lines across the screen.
The water may be deeper than the sonar’s ability to nd the 7.
bottom. If the sonar can’t nd the bottom signal while it’s in
the automatic mode, the digital sonar display will ash con-
tinuously. It may change the range to limits far greater than
the water you are in. If this happens, place the unit in the
manual mode, then change the range to a realistic one, (for
example, 0-100 feet) and increase the sensitivity. As you
move into shallower water, a bottom signal should appear.
Check the battery voltage. If the voltage drops, the unit’s 8.
transmitter power also drops, reducing its ability to nd the
bottom or targets.
This is likely due to cavitation (turbulence) in the water sur-1.
rounding the transducer. You may need to move the trans-
ducer lower in the water or to another location. The trans-
ducer cannot send or receive signals through air bubbles.
Electrical noise from the boat’s motor or trolling motor 2.
can interfere with the sonar. This causes the sonar to
automatically increase its discrimination or noise rejection
feature. This can cause the unit to eliminate weaker signals
such as sh or even structures from the display. Try using
resistor spark plugs or routing the sonar unit’s power and
Bottom echo disappears at high speeds, erratic reading
or weak bottom echo while boat is moving