Setting Operation Options . . . continued
used (except averaging value). Enabling "auto setup" will allow you to
select a global averaging measurement number (1- 5). The number
selected will override any number selected for individual "setups."
Because a measured reference is generated from a reflectance curve,
manual reference entry is not allowed when "auto setup" is activated.
☛
If any manually entered references exist in the instrument, a "CLEAR MANUAL REFS" message
will display if you attempt to turn on Auto Setup. Manual references must first be cleared before
"auto setup" can be activated.
Setup Limit - determines the number of "setups" that are available. Up to
"30" setups can be selected. The factory default setting is "30."
Group Limit - determines the number of "groups" that are available. Up
to "20" groups can be selected. The factory default setting is "20."
Wait On Fail - When the "Wait On Fail" option is set to "On", a key must
be pressed on the instrument to continue with measurement operation.
This occurs in pass/fail operation when a measurement fails. When the
option is set to "Off", an error alarm will be heard on a failed
measurement but no key depression is required.
To configure operation options:
☛
The configuration can be exited at any time by pressing [FUNCTION] key and [SETUP] key
simultaneously.
1) Press the [FUNCTION] key and
[SETUP] key simultaneously.
2) Press [FUNCTION] (no) two times.
E .85
FUNCTION SETUP REF
a* -.24 b* -.31
L* +.76
FUNCTION SETUP REF
no yes
CALIBRATE ?
PRESS TWO TIMES
7-2
➩
