Filter
Top Products
Steps
1. Locate the USB connector or USB key on the system board.
NOTE: To locate the internal USB connector on the system board, see System board
connectors .
2. If installed, remove the USB key.
3. Insert the new USB key into the USB connector.
Figure 53. Replacing the internal USB key
1. USB memory key 2. USB memory key connector
Next steps
1. Follow the procedure listed in After working inside your system.
2. While booting, press <F2> to enter the System Setup and verify that the USB key is detected by the
system.
System battery
Replacing the system battery
Prerequisites
1. Ensure that you read the Safety instructions.
2. Follow the procedure listed in Before working inside your system.
3. Remove the cooling shroud.
WARNING: There is a danger of a new battery exploding if it is incorrectly installed. Replace the
battery only with the same or equivalent type recommended by the manufacturer. See your
safety information for additional information.
119