Filter
Top Products
Figure 63. Removing and installing a 2.5 inch hard-drive blank
1. hard-drive blank 2. release button
Installing a 2.5 inch hard-drive blank
Prerequisites
1. Ensure that you read the Safety instructions.
2. If installed, remove the front bezel.
Steps
Insert the hard-drive blank into the hard-drive slot until the release button clicks into place.
Next steps
If applicable, install the front bezel.
Removing a 2.5 inch hard-drive blank (back)
Prerequisites
NOTE: This procedure applies only to PowerEdge R730xd systems.
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
Ensure that you read the Safety instructions.
CAUTION: To maintain proper system cooling, all empty hard-drive slots must have drive blanks
installed.
Steps
Pull the hard-drive blank out until it is free of the hard-drive slot.
136