Filter
Top Products
157
Recommended Tools and supplies
Recommended tools for this job include: wire pliers or wire stripper and
a
wire cutter. Required supplies for
this job include: two gray (18 gauge) o
r
blue (16 gauge) wire nuts and electrical tape. Supplies are not included.
Wiring Diagram "A"
Begin by stripping the wire ends of the device you're connecting to the Cud
a
350. (You'll notice the Cuda 350 data cable comes pre-stripped, with wir
e
ends exposed.) Use a pair of wire pliers to strip about 1/4-inch (6.35 mm) o
f
insulation from each of the radio's or other device's data wires.
Strip the ends of the VHF radio's data wires. Connect them to the pre-
stripped wires of the Cuda 250 data cable (shown right).
Twist the exposed wires together as shown in the following figures. I
f
you're using a Uniden or similar radio, connect the radio's NMEA Wire
to the Cuda 350 data cable's yellow wire, and the radio's Ground
/
Shiel
d
wire to the Cuda 350 data cable's black shield wire. If you're using an-
other radio brand or NMEA device, see Wiring Diagram B instructions
on page 161.