Filter
Top Products
162
Menus for changing Com Port settings.
If you need additional assistance in configuring the unit to communicate
with another device, consult the factory. Customer service phone num-
bers are in the back of the unit's manual. To set Com Port Configuration:
1. Press MENU|MENU|↓ to SYSTEM SETUP|ENT.
2. Press ↓ to
COM PORT|ENT.
A
menu appears with a drop-down Baud Rate selection box highlighted.
The menu also contains an on/off checkbox to activate NME
A
Input,
NMEA Output, NMEA GPS Input and a button that allows you to
Configure NMEA.
To set Baud Rate:
With the Baud Rate box selected (the title bar should be highlighted in
black, as in the middle figure above), press
ENT. A drop-down list ap-
pears, showing available baud rates. Select the one that matches the
baud rate on your VHF radio and press
ENT.
To activate NMEA Output:
From the Communication Ports menu, press ↓ to highlight NMEA In-
put. Press
ENT to turn on (check) or turn off (uncheck) the NMEA Input
checkbox.