Filter
Top Products
159
Wiring Diagram "B"
If your VHF radio or other device requires true RS-232, you will need to re-
move the diode and resistor built into the end of the Cuda 350 data cable.
Y
ou will notice near the end of the cable a segment protected with blac
k
heat-shrink. To connect the Cuda 350 to a true RS-232 radio, first re-
move the Uniden adapter segment of the cable as shown in the followin
g
figures.
For Wiring Diagram B installations, remove the Uniden adapter seg-
ment at the end of your data cable as shown at left. Snip off the end of
the cable protected by the black heat-shrink. At right, we have used
clear heat-shrink for clarity, so you can see the diode and resistor pro-
tected within. Remove this portion of the cable.
A
fter you have removed the adapter segment, use wire pliers to expose
the ends of the five remaining wires in the cable. Cut off the black, blue
and white wires, then seal their ends with electrical tape.