Filter
Top Products
14
Y
our Skimmer transducer typically comes packaged with a one-piece
stainless steel bracket for mounting it to the transom of your boat. The
optional trolling motor mount uses a one-piece plastic bracket with an
adjustable strap. These are "kick-up" mounting brackets. They help pre-
vent damage if the transducer strikes an object while the boat is moving.
If the transducer does "kick-up," the bracket can easily be pushed bac
k
into place without tools.
Read these instructions carefully before attempting the installation.
Determine which of the installation methods is right for your boat.
R
emember, the transducer location and installation is the mos
t
critical part of a sonar installation.
Recommended Tools and supplies
If you prefer the option of routing the cable through the transom, you wil
l
need a 5/8" drill bit.
NOTE:
The following installation types also call for these recommende
d
tools and required supplies that you must provide (supplies liste
d
here are not included):
Transom installation
Tools include: two adjustable wrenches, drill, #29 (0.136") drill bit, flat-
head screwdriver. Supplies: high quality, marine grade above- or below-
waterline sealant/adhesive compound.
Trolling motor installations
Tools: two adjustable wrenches, flat-head screwdriver. Supplies: plastic
cable ties.
Shoot-through hull installations
Tools: these will vary depending on your hull's composition. Consult you
r
boat dealer or manufacturer. Other tools are a wooden craft stick o
r
similar tool for stirring and applying epoxy, and a paper plate or piece
of cardboard to mix the epoxy on. Supplies: rubbing alcohol, 100 grit