Filter
Top Products
65
NMEA SETUP
Once you connect the wiring properly, the AccuNav
Sport must be told which NMEA data format to use.
Consult the owner’s manual of the other equipment to
see which format it needs. Then set the AccuNav Sport
as follows:
First, press the MENU key. Next, press the F5 (CHANGE
GPS SETTINGS) key. Now press the F2 (SELECT
NMEA/DGPS) key. The screen shown on the previous
page appears.
The data format currently in use shows at the top of the
screen. Press the key corresponding to the desired data
output. Now press the CLR key. The AccuNav Sport will
return to the last used GPS screen and send NMEA data
out the NDC-1 NMEA/DGPS interface cable.
DGPS (Differential GPS) BEACON RECEIVER SETUP
You'll have to tell the AccuNav Sport which beacon
receiver's data to expect and set up the parameters for
that data. To do this, first press the MENU key. Next,
press the F5 (CHANGE GPS SETTINGS) key. Now
press the F2 (SELECT NMEA/DGPS) key. Press the
key corresponding to
the desired beacon
receiver. Finally,
press the F6 (SETUP
BEACON DATA) key.
The screen shown at
right appears.
The station frequency
and bit rate are shown
on the right side of
the screen. Press the
F1 key which corre-