Filter
Top Products
1. OPERATION
1-30
[EDIT CHANNEL]
SELECT NO. : 0
TIME [UTC]
- -/- - - - -: - -: - -
FROM
MMSI:
- - - - - - - - -
TYPE: MANUAL
QUIT [MENU] EDIT[ENT]
[EDIT CHANNEL]
1/2
FROM MMSI:
_ _ _ _ _ _ _ _ _
POWER : 12.5W
CH NO. CH-A: 2087
CH-B: 2088
MODE CH-A: TX/RX
CH-B: TX/RX
ZONE: 1NM
1W
12.5W
1.9.2 Displaying, editing regional operating area status
You may display the status of regional operating areas currently memorized in
the equipment. Nine of any combination of AIS message from shore-based AIS,
DSC message, manual settings and commands from ECDIS or a PC may be
registered and one will be HIGH SEA.
About registering areas
• AIS and DSC messages registered within last two hours cannot be edited.
• An item labeled HIGH SEA cannot be registered. (“HIGH SEA” are data used
for international waters not controlled by shore-based AIS.)
• If two areas overlap one another the older data is deleted.
• Data older than five weeks is deleted.
• Area data is deleted when it is more than 500 miles from the area for which it
was registered.
1. Press the MENU key to open the menu.
2. Select CHANNEL SETTINGS then press the ENT key.
3. Select EDIT CHANNEL then press the ENT
key.
SELECT NO.: File number, 0-9. In order of
distance from own ship,
from closest to furthest.
TIME: Data and time equipment
controlled by external source.
MMSI: MMSI displayed for control by DSC or shore-based AIS.
Dashes or “EMPTY” (no data) otherwise.
TYPE: How channel is controlled: AIS, AIS message; HIGH SEA
(for reference setting), PI, ECDIS or PC; DSC, DSC;
MANUAL, manual control
Note: MMSI and TYPE must be set to other than “HIGH SEA” to edit.
4. Select desired file number from SELECT NO.
5. Press the ENT key to show details.
6. POWER is selected; press the ENT key to show the
channel power options.