Filter
Top Products
2. INLAND AIS
2-5
17. Select type of vessel/cargo, referring to the table on page 1-10, then press
the ENT key.
Note 1: Only the second digit for the type of vessel is entered here; the first
digit is entered on the initial settings menu, during installation.
Note 2: When “Tanker” is selected and the Nav status is “Moored”, output
power is automatically switched to 1 W when the SOG is less than 3 knots.
Further, in the above condition, when the SOG becomes higher than 3
knots, the pop-up message “CHANGE NAV STATUS?” appears and a beep
sounds. (The pop-up message “TX POWER CHANGED” also appears to
notify you that the Tx power has changed). To erase the pop-up message,
press any key or lower the SOG below 3 knots.
18. Press ► to go to the ERI CODE sub-menu.
[ERI CODE]
ERI CODE: 8000
****CODE DETAIL****
VESSEL,
TYPE UNKNOWN
19. ERI CODE is selected; press the ENT key.
20. Enter four-digit ERI code (type of ship), referring to the ERI code table in
the Appendix, then press the ENT key.
21. Press ► to go to the NO. OF PERSONS sub-menu.
[NO. OF PERSONS]
CREW:
_ _ _
PASSENGER:
_ _ _ _
SHIPBOARD PERSONNEL
_ _ _
NO. OF PERSONS: 0
22. CREW is selected; press the ENT key.
23. Enter number of crew (0-254) then press the ENT key.
24. PASSENGER is selected; press the ENT key.
25. Enter number of passengers (0-8191) then press the ENT key. Enter "8191"
if the total number of passengers is more than 8190.
26. SHIPBOARD PERSONNEL is selected; press the ENT key.
27. Enter number of shipboard personnel (persons other than passengers and
crew, 0-254) then press the ENT key.
Note: Crew, passenger and shipboard personnel are sent in RFM55
messages.
28.NO. OF PERSONS is selected; press the ENT key.