Filter
Top Products
2-5
2.2 Display Unit
Switch S2 (AC spec. only)
The display unit designed to run on AC power has a switch (S2)
at its rear to cut off 100/200 VAC power to the display unit. To
access the switch, unscrew two screws and then slide cover
to remove it. TURN THE SWITCH OFF WHENEVER ACCESSING
INSIDE THE DISPLAY UNIT.
Switch S2
Fabricating the power cable CVV-S 8X2C (option)
1. Remove the vinyl sheath by 40 mm.
2. Cut off jute tape wrapped around the armor.
3. Unravel the armor to expose the cores.
4. Remove insulation of cores by about 10 mm. Fix crimp-on lugs to the cores and armor.
5. Cover the armor with vinyl tape, leaving the portion which will lie inside the cable clamp
untaped.
About 40 mm
CVV-S 8X2C
Braided shield
Core
Crimp-on lug
Figure 2-8 Fabrication of power cable CVV-S 8X2C