Furuno FR-1760DS Marine RADAR User Manual


 
2-7
4. Connect wiring to the SPU Board as shown in the interconnection diagram and Chap-
ter 3. Fasten shields of cables to chassis.
5. Cover the cable clamp with aluminum tape (about 50 mm in width) to keep foreign
objects out of the display unit.
Cable clamp
Aluminum tape
(About 50 mm in width)
Cable
(Power, signal, etc.)
Figure 2-11 Covering the cable clamp with aluminum tape
Ground
Run a ground wire (IV-8sq or equivalent) between ground terminal on the display unit and
ship’s superstructure.
Ground the equipment to
prevent electrical shock
and mutual interference.
CAUTION