Filter
Top Products
P0992639 01 Modular ICS Companion Installer Guide
Programming
Programming is performed by the installer or the customer
service representative. The interface allows you to change
settings for the entire Norstar system, plus settings for
individual telephones and external lines. Most of the settings
can also be programmed by a system coordinator who has a
SysCoord+ password. This password is distributed only by the
installer to avoid system complications.
Installation programming
Before you attempt to program the Companion sets,
familiarize yourself with the Programming section of the
Modular ICS Installer Guide. The section explains the four
types of passwords and the menus each password can
access.Not that that the Companion prompts are only visible
through the MICS-XC software.
For information about Companion set programming using the
System Coordinator and Basic passwords, refer to the
Modular ICS Companion System Coordinator Guide.
Programming affects system operation.
Only a qualified installer or customer service
representative should perform startup, installation and
maintenance programming. Some of the settings affect
the correct operation of the system.