Filter
Top Products
Programming /
71
P0992639 01 Modular ICS Companion Installer Guide
3. Press ≠. The display reads Key 1:_.
4. Enter the 8 digit password number for Key 1. Use BKSP to
make corrections. The display reads Key 2:_.
5. Enter the eight-digit password number for Key 2. Proceed
as above until you have finished entering Key 3. The
display reads Entry successful.
6. Repeat steps 3 through 5 for the other key.
7. Press– until the display reads Software keys or
to exit.
The system automatically starts reevaluation and the
display shows Re-Eval in prog. , Re-Eval complete,
System online, as the reevaluation runs its course.
Note: If the UTAM Activation Code entry is unsuccessful, the
display shows Invalid code. If this happens, reenter
the code or call Nortel Customer Response Center at
1-800-321-2649 for assistance.
Step 5: Configure base stations and portables
Once you have entered the required keys to activate the base
stations and to obtain enough portable credits, you can proceed
with programming these items with the MICS-XC system.
Configure your base stations
Companion base stations are recognized by the MICS-XC
system once the UTAM activation keys have been entered. To
verify whether or not the base stations have been properly
recognized, see Radio data on page 62 for information on the
re-eval process.