Filter
Top Products
Programming /
55
P0992639 01 Modular ICS Companion Installer Guide
Startup programming
Before you perform Companion programming, your system
should be running and configured.
Startup programming is explained in the Modular ICS
Installer Guide.
Performing Startup
1. Enter the Startup access code from a M7310, M7324 or
T7316 telephone dialpad, by pressing
which is the same as
.
To be accepted, the Startup code must be entered no later
than 15 minutes after the Norstar system has been powered
up.
If 15 minutes have elapsed since you powered up the
system, turn system power off and on, to prepare for the
Startup process.
2. Enter the Installer password. The default is
which is the same as
.
Startup erases programming.
Startup erases any existing programmed data,
and resets the system to factory defaults.
Tip -
The Installer password shown is the default
normally used for Startup. For a system which has
already been programmed, the Installer password might
have been changed in programming and recorded in the
Programming Record.