Filter
Top Products
66
/ Programming
Modular ICS Companion Installer Guide P0992639 01
Cell rad nghbrs
This sub-heading allows you to view the two-digit number of
any cells that border a particular cell in a system, these are
called cell neighbors. As well, you can view any cells that
border the cell neighbors. Press ≠ and enter the cell
number to see the settings: Assigned or Unassigned. Select
LIST to see each neighbor in sequence. Select SCAN to see the
first/next cell Assigned.
For example cell 01, the display shows Rad nghbr:03,
Rad nghbr:04, and Rad nghbr:11. Cell 11 does not appear as
a cell neighbor (see the example under Cell nghbr), so it must
be a neighbor of cell 03 or 04.
System logical identifier (LID)
This setting allows you to change the code by which the
system identifies itself to portables and which the portables
use to request service from the system. The default setting is
randomly generated by the system at start-up. When the
system logical identifier (LID) is changed, all portables must
register again.
When changing the system LID, you can enter any
hexadecimal number between 0500 and FFFE.
Note: Hexadecimal characters can only range from 0 to 9 and
A to E.)
Changing system LID de-registers all
portables.
If you change the system LID, you invalidate the
registration of all the portables in the system.
Portables must be re-registered before they can
be used.