Filter
Top Products
Installing Telephones and Other Equipment
CAUTION:
PARTNER phones must be connected with a
2-pair telephone wire. Other equipment must be connected
with a 1-pair mounting cord (AT&T D2R mounting cords
recommended).
DESK MOUNTING A PARTNER PHONE
Plug one end of the handset cord into the jack on the handset.
Plug the other end of the cord into the small jack on the left
side of the base.
Plug one end of the telephone mounting cord into the big jack
on the base of the phone. Push the cord in place along the
channel on the base of the telephone.
If you want to raise the angle of the phone, install the telephone
stand. To attach the stand to the base of the phone, gently
place the phone upside down with the low end of the phone to
your right. Insert the tab on the narrow end of the stand into the
right slot on the base of the phone. Then insert the other tab
into the left slot, pushing the stand down and slightly inward
until the tab locks into place.
Plug the other end of the mounting cord into the modular wall
jack.
Test the intercom. Lift the handset, then press an [Intercom]
button. You should hear an intercom dial tone. If not see
chapter 8, in the System Manager’s Guide (“Phone Has Lights
but No Dial Tone”).
TE
To t
1
2
3
Test the outside line connection. I-M the handset and press an
outside line button. You should hear an outside dial tone. If not,
see chapter 8, in the System Manager’s Guide (“Phone Has
Lights but No Dial Tone").
Slide theQuick Reference card under the telephone.
Label the button sheet and insert as follows:
1
Remove the clear plastic cover from the phone--gently
press down on the center tab, then lift.
2
Place a button label sheet on the phone so the holes on the
sheet fit over the buttons.
3
Replace the plastic cover.
ST PROCEDURE FOR PARTNER PHONES
est the power and lights on a PARTNER phone:
Press and hold [#] button for 5 seconds.
Before releasing the [#]
button, lift the handset. All lights
should light, the ringer should sound, and on the PARTNER
display phone, a test pattern should appear on the display.
If not, call the Helpline at 1 800 628-2888.
Replace handset. The phone is in normal operating mode.
Figure 2-2 Desk Mounting a PARTNER Telephone
2-4 Installing the Hardware