Filter
Top Products
Dial Mode
Code: #201
Description:
Identifies each outside line as either touch-tone or rotary.
Valid Entries:
✓
1
=
Touch-tone line
2 = Rotary line
Considerations:
If you are using touch-tone phones on rotary lines, you may
need to adjust the Rotary Dialing Timeout (#108).
Programming Steps:
1.
Press [ Feature ] [ 0 ] [ 0 ] [ System Program ] [ System Program ] [ # ] [ 2 ] [ 0 ] [ 1 ] . The
display reads:
Dial Mode
Line:
2. Enter the first line to be programmed. For example, to program line 8,
press [ 8 ] . The display reads:
Dial Mode L8
1 Touch Tone
3. To change the dial mode, press [ Next Data ] . The display reads:
Dial Mode L8
2 Rotary
To program another line, press [Next Item] or [ Prev Item ] until the correct line number shows
on the display. Follow step 3 to change the dialing mode. Repeat for all lines that you
want to change.
✓ = Factory Setting
To go to the next procedure: [ Next Proc ]
To go to a specific procedure: [ # ] [ 2 ] [ 0 ] [ 1 ] . The
To go to the previous procedure: [ Prev Proc ]
(where XXX is the procedure number)
To return data to the factory setting: [ Remove ]
To exit system programming: [ Feature ] [ 0 ] [ 0 ]
System Programming 3-9